Jump to content

Introduction to Electronics/Lecture Soldering

Add links
From Wikiversity

The tools you need for soldering are solder and a soldering iron. You first need to heat the soldering iron so that the solder will immediately fuse when it touches the solder. When it's already heated, you then touch the leg of your targeted component. Let the leg be heated for a few seconds before touching it with the solder. Don't melt too much solder and make sure it does not make contact with any conducting area on your circuit board unless intended.


EE90 Edit/View

Soldering on wires

[edit | edit source]
In this method first - heating the wires and then to this point adds the solder

Soldering on a heating element

[edit | edit source]
In this method - melting the solder on the heating element. And then transfer to wires.

References

[edit | edit source]

https://www.science.smith.edu/~jcardell/Courses/EGR328/Readings/Soldering%20Guide.pdf

Back to: Topic:Electronic Engineering

EE90 Edit/View

* Electronic Engineering * EE Introduction to Electronics * Lecture, Test Equipment * Lecture, Smart test equipment * Lecture, Mounting Techniques * Lecture, Soldering * Lecture, Schematics * Lecture, SPICE * Mid-term Exam * Final Exam

Resource type: this resource contains a lecture or lecture notes.



Retrieved from "https://en.wikiversity.org/w/index.php?title=Introduction_to_Electronics/Lecture_Soldering&oldid=2591125"