Power Supply Testing/Tutorial to drill holes on the power supply shield
(Redirected from Tutorial to drill holes on the power supply shield)
- 1. Remove the power supply shield
shield - 2. Put the power supply shield on the vise grip
shield in the grip - 3. Get a cup of oil.
oil 
not water - 4. Put a small drill bit in the drill. Adjust it so that is tight. Dip it in the cup of oil.
- 5. Start drilling until one makes a hole.
small hole - 6. Change the drill bit. Increase the size. Dip it in oil
- 7. Start drilling a bigger hole.
drill a bigger hole - 8. Change the drill bit. Increase the size. Dip it in oil
- 9. Start drilling bigger hole than previous one.
even bigger hole - 10. Change the drill bit. Increase the size. Dip it in oil
- 11. Make the last hole (the hole should be as big to fit the bin post)
final hole - 12. Put the bin post
put the bin post - 13. Repeat steps 4-12 four more times to make the five holes.
5 bin posts
